Warning: We recommend that you have a professional installer to do this job for you if you don't have any ELECTRICAL experience before!!
At the plug where your Factory Power unit was plugged into, test with a logic probe or power probe, which wire has 12 volts on when you adjusting left. This is the wire that you will need to connect the RED wire then find the ground wire (connect to the BLACK wire) for it from the factory harness. When you adjusting to the right, those RED and Black wire should be reversed. Repeat the last step again for up/down and then connect the WHITE wire to it.
For the LED light that use as turn signal option, you will need to get a RELAY kit for easier installation without damage/affect factory wiring harness.
TIP: Many power units have a plug that you can cut off and wire to your new power unit so you can plug it directly into the factory plug. Use this method if has a plug that you can cut off.
Left mirror: Red - Up, White - Right
Right mirror: Red - Left, White - Down
No comments:
Post a Comment